Shield Prime Bedwetting Alarm

Initial Setup
Fasten the bedwetting alarm unit to the outside neckline or around arm with optional armband accessory (sold separately).
shield

Lift the lever of the Strong Hold Sensor and gently insert the folded underwear into the sensor. Lower the lever to get a good grip. Gently pull on the sensor to ensure that it is a snug fit and won’t come off at night.

shield

Now, run the cord under your child’s shirt and insert sensor plug into sensor jack of the alarm unit.

shield

If using a diaper, first attach the sensor to the outside of your child’s undergarment and follow instructions in the previous section. Wear the diaper on top of the attached sensor so that the sensor is sandwiched between the underwear and diaper.

shield

 

Bedwetting Alarm Adjustment
Each time bedwetting is detected, Shield Prime plays an alert tone. You can only add remove vibration from a tone.
Disconnect the sensor from the alarm unit by removing the sensor plug from the sensor jack. Shield prime bedwetting alarm can be programmed with one program button that allows you to choose from sound and vibrate, sound (only) and vibrate (only) mode.
shield

Sound only mode: Briefly press the program switch till only sound is played back.
Sound and Vibration mode: Briefly press the program switch till both sound and vibration are played back.
Vibration mode: Briefly press the program switch till the alarm unit only vibrates.